The SSA3 is a combination wired and wireless Siren & Strobe Alarm that can be integrated in to your Zwave automation network, or can be used with traditional wire trigger from a security control panel. It will sound a loud siren and flash a strobe light when an alarm message or alert is received on any Z-Wave enabled network.
SSA3 will sound a loud audible alarm >105dB @ 1M, and a strobe lighting when an alarm signal is received from a device in the Z-Wave home network.
The SSA3 also extends the range of existing Z-Wave devices in the mesh network by acting as a signal repeater.
The SSA3 is tamper proof as it uses 9V battery backup to sound alarm if AC power is disconnected / cut.
The SSA3 is fully programmable with Z-wave smart controllers to provide the audible and visual notifications you set for your automation and/or security network.
- Siren ONLY mode
- Strobe ONLY mode
- Strobe & Siren Mode
Note: A SSA3 unit WILL ALERT you from the home security panel only if correctly connected to the panel but if it is not in a Z-WaveTM network WILL NOT alert you wirelessly by the siren nor by the strobe alarm.
Unit is not recommended to be used in direct exposure to harsh elements, rain, snow, and sun.
- Power: DC Power adapter 9V to 16V/300mA or wire from Security Panel (plug-in adapter included)
- Distance Range: Max 100ft line of sight in unobstructed environment,
- Product Size (LxWxD): Approx 200mm x 10mm x 60mm height,
- Product Weight: 500g (1 lb) total weight including power adapter,
- Operating Temperature: -10ÂºC (14F) to +70ÂºC (158F)
- Sound Intensity: 120dB @10cm; 105dB@1m
- Anti-tamper switch: included
- System Requirement: Any Z-WaveTM enabled network and controller.
The SSA3 is based on wireless (RF) transmissions. Any wireless transmission can be subject to RF interference and, although unlikely, this interference may cause the SSA3 to not operate as intended. RF transmissions will be attenuated by tinted glass, in wall isolation with metal foils, metal objects etc. Test communication to the SSA3 before final placement. Add additional Z-Wave repeater modules to improve RF communication if necessary. Z-Wave is a mesh network; more units, the better the communication.
The SSA3 must not be used in life support and/or safety applications. Information provided in this document is for your convenience and may be superseded by updates to either the document or the product. It is your responsibility to ensure that the SSA3 meets with your specifications.
- Additional Information
Brand No Custom Stock Status Message N/A